• Make sure that your E-bike is inspected by an authorized
GenZe dealer or at a GenZe Service Center at least once a
year. Find the nearest to you by calling us at 1-855-GO-GENZE.
• If your e-bike fails to work properly, consult your retailer.
• It is important that your e-bike is well maintained in order to
prolong its life.
• Have your brake pads replaced if they are worn out.
• Use only genuine replacement parts when your e-bike
is serviced.
• Any injury or damage resulting from your failure to fully
understand this manual or negligence will not be covered
under the Product Liability.
7. Inspection, Maintenance & Dimensions
Do not lubricate between the brake shoe and the rim.
Caution:
Frequency Component Lubricant How to Lubricate
Chain Chain Lube or Light Oil Brush On or Squirt
Derailleur Pulleys Chain Lube or Light Oil Brush On or Squirt
Brake Calipers Oil 3 Drops from Oil Can
Brake Levers Oil 2 Drops from Oil Can
Shift Levers Lithium Based Grease Disassemble
Freewheel Oil 2 squirts from Oil Can
Brake Cables Lithium Based Grease Disassemble
Yearly
Bottom Bracket/Pedals/Derailleur Cables/Wheel
Bearings/Headset/Seat Post
Lithium Based Grease Disassemble
Every
Six Months
Weekly
18 / 19
• Recharge the battery fully before leaving it for an extended
period of time. Make sure that it is recharged at least once
every 10 days whether you use it or not. (Recharging may not
be possible if it becomes fully discharged.)
• Protect the battery from rain or moisture, which could cause
it to fail.
• Charge the battery in environments between 15°F and 100°F.
1. On/Off Switch: Controls the power supply to the instrument panel.
2. Mode Switch: Press to change the e-bikeʼs operation mode.
3. Riding Mode Switch: Press to change riding modes between Level 1
(low speed, regular surfaces) and Level 5 (high speed, downhill).
To switch from to kph to mph, or vice versa, press and hold both the
plus and minus buttons simultaneously on the pedal assist control
module for 5 seconds.
4. Riding Speed Indicator: Indicates the current speed of the e-bike.
5. Distance Covered and Time Elapsed: Indicates the distance the
e-bike has covered and how much time has elapsed in the
current ride.
Names and Functions of the Instrument Panel
1
2
3
4
5
6. How to Operate Your Electric Bicycle
To Next Page
Loading...
