GENZE E102 - Inspection, Maintenance and Dimensions; Instructions for Riding Your Electric Bicycle

20 / 21
Riding Using Pedals When the Power Switch on the E-Bike is Off
8. Instructions for Riding
Your Electric Bicycle
1. Install the battery.
2. Turn the e-bike on.
• You can use your bike in pedal assist mode (modes 1, 2, 3, 4,
and 5) or as an e-bike by twisting only the throttle in 0 mode.
• Note that the e-bike mode requires the inside part of the
right grip/throttle to be twisted slightly.
• When the instrument panel turns on, Pedal Assist 1 is the
default mode.
o Starting at Pedal Assist 1 is required to avoid an accident
and to prevent sudden acceleration.
3. Pedal slowly at Pedal Assist 1 to start the motor.
o The motor wakes up when the crank rotates at least
45 degrees.
4. Press the riding mode switch at Pedal Assist 1 to adjust up to
speed 5.
o In general, regular surfaces require a lower speed, and
downhill requires a higher speed.
5. Pressing either brake will deactivate the motor.
6. Disconnect the battery if you will not use the e-bike for an
extended period of time.
• This function is the same as riding a regular bicycle.
• Select speed 4 on the right shifter when riding on a regular
surface in pedal mode.
• In e-bike mode, the recommended positions for the right shifter
are between speeds 4 and 6 on regular surfaces and between 1
and 3 for downhill sections.
Parts that require lubrication
and where to check before a ride
Rear brake
Brake lever
Brake shoe
Handle stem
Handlebar
Seatpost
Chain
Rim
Pedal
Hub nut
Tire
No lubrication
No lubrication
No lubrication
No lubrication
Brake lever
(front and rear)
Chain (lubricate
while pedaling)
Rear derailleur
(Lubricate the
moving part)
Front derailleur
(Lubricate the
moving part)
Motor:
• Do not attempt to disassemble the electric motor on your own.
Consult your local authorized retailer or a GenZe Service Center to
check parts for wear or to lubricate applicable components.
Find your nearest location by calling us at 1-855-GO-GENZE.
• Check that the motor is securely assembled before every ride.
If it is loose, contact your local authorized GenZe retailer or a
GenZe Service Center.
Do not modify your e-bike on your own. Contact us at
1-855-GO-GENZE or consult one of our dealers prior to any
modification. Failure to do so could invalidate your GenZe warranty.
You are required to follow all traffic laws, regulations, and signals
when you ride your e-bike.
7. Inspection, Maintenance
and Dimensions