Geo Minim+ - Installation Guide; Attach the Sensor; Activate the Transmitter

4 easy steps to install
1. Attach the sensor
1. Find the pulse output on your meter.
2. Stick the square Velcro around the pulse output
on the meter.
3. Place the LED sensor over the square Velcro on the
meter ensuring that the geo logo is facing you.
4. Insert the other end of the LED cable to the bottom
of the transmitter.
2. Activate the transmitter
Open the transmitter by pressing the button on
the back and pulling the outer cover away. Remove
the battery tab. The red light will ash to show the
unit is working.
Battery tab
Flashing red LED
Button A
1 2 3 4
Pulse output
(imp/kWh)