Need help?Do you have a question about the Geo solo and is the answer not in the manual?
Describes the main unit for viewing energy generation data wirelessly.
Unit that sits next to the meter and sends readings to the display wirelessly.
Provides power to the display unit. Use only the supplied adapter.
Attaches to meter's LED to measure energy generation pulses.
Three black buttons located under the display used for setup and navigation.
Procedure to configure the device's date and time settings.
Configure PV array size and currency/tariff rates for accurate earnings display.
Adjust backlight behavior to save power, with options for off or sleep modes.
Configure display sleep and wake-up times for overnight operation.
Configure the pulse rate for the LED reader to accurately measure generation levels.
Instructions for performing a factory reset of both the display and transmitter.
Shows current electricity generation in various units like kW, currency, or CO2.
Displays total electricity generated today, yesterday, last 7 days, or since installation.
Indicates when enough electricity is generated to power heavy-load appliances.
To Next Page
General
