14 | geo helpline: 0845 519 7226
Frequently asked questions
Q. The transmitter is not ‘paired’
transmitter off and then on again (simply
Wait for a couple of seconds and the display
Press the
Set button to go back to the main screen.
You may need to do this
more than once.
Q. Why won’t my display and transmitter
communicate?
The Solo is designed to operate in a home
display to a different location or follow
Radio communication doesn’t work as well
Q. Why is the Communications icon flashing?
The Communications icon will flash if the display
and transmitter are unable to communicate
Q. The Communications icon is on but the
display is still not receiving information
Q. Why is the Battery symbol flashing?
We expect the transmitter batteries to last for
Battery symbol will flash to let you know to
Q. The screen display turns off, what can I do to stop
this?
Solo can be run off batteries for short periods of
time but is designed to run off the mains adapter
Q. Can I use the Solo’s generation information to
give to my energy suppliers?
Q. I want to move the unit to another property,
how do I erase data?
generation data and tariffs disconnect the display
Q. Can I use more than one display?
Q. What do I need to do if I have entered the wrong
date during setup and continued using my Solo?
to erase all data that has been recorded onto the SD
and then change the date on the Solo display (see
card into your computer (either using the SD port or
a card reader) and erase all the data that is stored on
Q. What are the values for each segment of
the Speedometer?
table below shows three figures; the first shows
To Next Page
Loading...
