1.4.16
CARRYING OUT A MEASUREMENT CHAPTER 4
GEODIMETER SYSTEM 600
P22 13.38
HT measure?
P22 13.39
Aim to point
Press REG
If heights are to be measured the next
question would be IH (instrument
height). In this example we will press
NO, which means that instrument and
signal height is not taken into account.
Here you have the opportunity to ckey
in a Pcode. We will answer NO ...
Key in the number of the first target at
which you wish to begin your angle
measurement, e.g .200 ENT...
Make a coarse aiming towards the first
target, then press REG.
P22 13.39
Pno=_
P22 13.39
Pcode?
From previous page
See next page
PRG
22
C2 + C
NO
NO
ENT
REG
To Next Page
Loading...