5
BEFORE FIRST USE
• Remove all packing materials.
• Hand wash the removable parts.
• When using the Cyclo Chef Multi Air Cooker for the rst time, you may notice smoke
or a slide odour for the rst few minutes of cooking. This is normal. Ensure the room is
well ventilated.
DISPLAY
During use, the display alternates between showing the current temperature and the
default program time for the currently selected program. If a program is already running, the
display will show the remaining program run time. When the temperature is displayed, the
temperature button ( ) will ash. When the time is displayed, the time button ( ) will ash.
PROGRAM GUIDE
You can change the default program temperature and program run time.
Program
Default Settings Adjustable Range
Temperature ºC Time (mins) Temperature ºC Time (mins)
Air Fry 220 30 150 - 220 1 - 60
Roast/Bake 175 30 100 - 220 1 - 60
Grill 160 15 120 - 220 1 - 60
Rotisserie 190 30 120 - 220 1 - 60
• To select a program, press the relevant button shown above.
• To change the temperature, rst tap the temperature button ( ) then use the up (u)
and down (d) arrows to select the desired temperature.
• To change the program run time, rst tap the time button ( ) then use the up (u) and
down (d) arrows to select the desired time.
• If required, you can change the time and temperature settings using the same method
while the program is running.
AIR FRYING
1. Unplug your Cyclo Chef Multi Air Cooker.
2. Remove basket lid and place the items to be fried into the basket. Don’t overll the
basket. Allow enough space for air to circulate and the ingredients to move freely (g A).
3. Fit the lid onto the basket (g. B).
4. Insert the drive shaft into the opening in the bowl (g. C)
5. Lower the basket down until the two holes in the handles t over the two pins in the
body of the fryer (g. D). The lid won’t close unless the pins pass through the holes in
the handle.
6. Plug in your Cyclo Chef Multi Air Cooker. The unit will beep and the display will light up briey.
7. Tap the power button ( ).
To Next Page
Loading...
Need help?
General
