Voltage Recording
Curve based voltage logging to detect weak batteries, failing
alternators, and failing starters.
Heartbeat
Device wakes out of sleep mode at pre-defined intervals to send
buffered data, such as position and voltage data.
Antennas (GPS and cellular) Internal
Accelerometer
3-axis accelerometer for low-voltage digital output linear MEMS,
housed in an LGA package. Full scale (±2g, ±4g, ±8g and
±16g), capable of measuring accelerations with an output data
rate of 100 Hz or 400 Hz.
Installation Simple plug and play
Intelligent Ignition Detect
Non-engine based ignition detect based on voltage and
movement allowing for 2-wire installation. Perfect for older
vehicles with no engine information and covert installation for
asset recovery.
GPS Receiver
UBX-G6010-ST
Voltage: 2.5 V to 3.6 V
50-channel u-Blox 6 engine
Under 1 second Time-To-First Fix for hot and aided starts.
Hybrid GPS/SBAS engine (WAAS, EGNOS, MSAS)
3GPP compliant
A-GPS: AssistNow Online and AssistNow Offline services
Cellular Module
GO7 2G: MT6252A chipset(M5206 2G Module)
o GSM/GPRS: 850/900/1800/1900
GO7 3G: MT6276A chipset(M7600 3G Module)
o GSM/GPRS : 850/900/1800/1900
o UMTS: Band I/Band II/Band V
Voltage: 3.8 V
CurrentConsumption: 500 mA @ 4.2 V (2G)
400 mA @ 4.2 V (3G)
Embedded TCP/IP stack
Certifications: PTCRB. Other certifications pending.
Installation Instructions
Before installing your GO7™ device, ensure no dash warning lights are on in the vehicle while it is
running. Also verify device compatibility with your vehicle type with your reseller.
GO7™ Installation
1. Locate the vehicle’s engine diagnostic port typically found in the
driver’s area at or below knee level. Note: Commercial vehicles
with diesel engines use a different connector system. Contact
your reseller for diesel connector applications or for extension
harnesses should it be necessary to locate your GO7™ away
from the engine diagnostic port location.
To Next Page
Loading...
Need help?
General