Status field
Choosing Recording Mode
You can set each camera's recording mode individually for Motion Detection or
Round-the-Clock.
1. Click on the main screen, point to General Setting, and select System
Configure.
2. Click the Camera Record Setting tab.
3. From the Camera Name drop-down list, select one camera.
4. In the Monitor Control section, select Rec Video, and use the drop-down list
to select Motion Detect or Round-the-Clock.
5. Click OK.
For details on setting camera properties, refer to Adjusting Individual Camera,
Chapter 1, DVR User's Manual (GV-Desktop < Program button < Multicam
Installation).
4
3
2
4. In the MedianMan Tools window, if the hard drive is successfully added to store
data, its Status field should display “Standby”.
5. To add another formatted hard drive for storage, repeat the above steps.
Renaming the Camera
You can give a new name for each camera.
1. Click on the main screen, point to General Setting, and select System
Configure.
2. Click the Camera Record Setting tab.
3. In the Camera Name field, enter a new name for the camera.
4. Click OK.
For details, see 3.6 Adding the External Hard Drive to the Recording Path in
GV-NVR System Lite User's Manual.
To Next Page
Loading...
Need help?
General
