MISSING DEVICE
Description:
Some plotter option is activated but the master board cannot reach the
device by I2C bus.
It is only displayed momentarily on start-up.
(As example, the automatic cutter electronics not connected).
1. Verify the connection is properly done
2. Contact Service
CALENDAR FAILURE
Description:
Error in the calendar masterboard controller. Plotter cannot start.
1. Restart plotter and check again.
2. If it doesn't work, it needs an activation code that will set the new
date and time.
3. Contact Service.
BATTERY FAILURE
Description:
Masterboard battery is not working. Plotter cannot start.
1. Restart plotter and check again.
2. If no succeed masterboard should be replaced.
EEPROM FAILED
Description:
EEPROM has corrupted data and cannot be recovered.
It can be formated but some information will be lost.
1. Restart plotter and check again.
2. Reset EEPROM: Restart plotter and keep pressed MENU and
CANCEL keys during start-up. In this case verify the default settings and
recalibrate the plotter.
This operation must be authorized by a master technician.
3. Replace masterboard if necessary.
To Next Page
Loading...
