Need help?Do you have a question about the Gerber Technology MP+ 1800 and is the answer not in the manual?
General| Model | MP+ 1800 |
|---|---|
| Category | Plotter |
| Manufacturer | Gerber Technology |
| Max Plot Width | 72 inches |
| Media Type | Mylar |
| Resolution | 0.0005 inches |
| Interface | RS-232 |
| Maximum Media Width | 193 cm (76 in) |
| Cutting Speed | Up to 113 cm/sec (44.5 in/sec) |
Adjusting the distance between cartridges in the X-axis.
Adjusting the distance between cartridges in the Y-axis.
Calibrating the Y-axis encoder for accurate paper feed.
Performing a precise angle test with all installed cartridges.
Ensuring equal deck height across measurement points for parallelism.
Adjusting print height for alignment in bidirectional printing.
Troubleshooting common issues related to plotter firmware versions.
Steps to diagnose and resolve plotter power-up failures.
Resolving issues related to plotter RAM memory accessibility.
Troubleshooting problems with the plotter's SD card.
Diagnosing and fixing errors on the USART bus.
Troubleshooting common plotter movement errors and alerts.
Diagnosing and fixing plotter overspeed conditions.
Resolving overload conditions in plotter motors.
Troubleshooting issues with motor driver firmware.
Diagnosing and resolving X-axis encoder errors.
Troubleshooting general plotter movement failures.
Resolving problems related to paper jams and movement mismatch.
Diagnosing and resolving software-related printing errors.
Guide to diagnosing and resolving issues with plotter sensors.
Troubleshooting when the plotter does not detect available cartridges.
Troubleshooting cartridge detection failures on 4PH plotters.
Main issues related to the overall print quality of the plotter.
Guide for replacing the FFC flat flexible cable.
Instructions for replacing the plotter's encoder strip.
Guide for replacing the carriage electronic board (PH board).
Procedures for replacing the master board and installing firmware.
Step-by-step guide for replacing the plotter's master board.
Instructions for activating Device Firmware Upgrade mode.
Guide for installing firmware on MP plotters using Gerber Maintenance Tools.
Installing firmware using an SD card.
Installing firmware via Server Manager.
To Next Page
