P.9
Installation Instructions
1. Put the “connecting rod” downward vertically, inset It into the position of ‘main
shaft base” (align the up and down card slots) put the M6 screw through the
screw hole at the base center and then tighten the screw in clockwise.
M6 screw
Screw thread
No screw thread
2. Insert “fan body” into “connecting rod” (align the up and down card slots), tighten “nut of main
rod” and nish installation of fan body after conrming that there is no waggling of fan body.
Watch the video clip
card slots
To Next Page
Loading...