Packed Airlock
1. Sleeves with gloves and O-rings
2. Cleaning kit with stainless steel cleaner,
abrasive pad, hanging hooks and scratch
remover
3. Complimentary box of gloves
Additionally- 1-Yellow Electrical Outlet
Cord (cannot be seen in this picture).
Installation
The Laminar Flow Glovebox /Isolator was designed to fit through standard size doors
allowing for easy installation (32” Deep and 80” High).
The Laminar Flow Glovebox /Isolator is a complete and self-contained unit and is shipped
fully assembled. After unpacking, the unit can be moved into the desired location. Unlike an
open front hood room air currents do not disrupt the LFGI; however, proper room
placement and room access may be defined by professional and/or State regulations.
The external clean air plenum may be removed if it is discovered that the unit is too wide to
fit through a door. The Prefilter housing at the top of the LFGI can be removed if the unit
is too tall. Please call GERMFREE (800) 888-5357 for instruction if either of these is
necessary.
The sleeves and gloves will need to be installed before turning the unit on. See section on
Sleeve and Glove Changes.
15
To Next Page
Loading...
