Procedure for Changing Gloves During Maintenance
Your standard two-part glove consists of:
1 Glove Sleeve
1 Disposable Glove
1 Glove Over Sleeve (GOS), a 3” diameter ring with three grooves on the outside
2 Glove O-rings, rubber rings that can stretch to fit around the GOS
2 Sleeve O-rings, rubber ring that can stretch to fit around the 10” gloveport
1) Pull the Glove and Sleeve out of the work area so that the sleeve is inside out and pull the
existing glove and securing O-rings off.
Glove Over Sleeve
2) Fold the sleeve back over the GOS so that the end of the sleeve is even with the end of
the GOS.
To Next Page
Loading...
