EasyManua.ls Logo

Gestetner DSm415 - Page 100

Gestetner DSm415
146 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Appendix
94
9
Display
Shows SNMP information and
available protocols.
msh> snmp ?
The following command displays
the settings of registered number
specified.
msh> snmp [registered_number]
Omitting the number displays all
access settings.
msh> snmp [-p]
Note
Add -p (as above) to have the
information displayed one
screen at a time.
Community name configuration
You can set the community name
of the registered number.
msh> snmp number name
community_name
Note
The community name can con-
sist of up to 15 characters.
Access type configuration
You can select the access type from
those listed below:
msh> snmp number type
access_type
Protocol configuration
You should use the following com-
mand to set protocols to active or
inactive. If you set a protocol to in-
active, all access settings for that
protocol will be disabled:
msh> snmp {ip | ipx} {on | off}
•“on means active, off means
inactive.
To change an access setting proto-
col, use the following command.
However, if you have disabled a
protocol using the above com-
mand, making it active here will
have no effect.
msh> snmp number active
{ip | ipx} {on | off}
Access configuration
You can configure a host address
according to protocols used.
The network interface board ac-
cepts requests only from hosts with
read-only or read-write access
type addresses. Enter 0 to have
the network interface board accept
requests from any host without re-
quiring a specific type of access.
msh> snmp number {ip | ipx}
address
Note
To specify TCP/IP protocol, en-
ter "ip" followed by a space, and
then the IP address.
To specify the IPX/SPX proto-
col, enter "ipx" followed by a
space, and then the IPX address
followed by a decimal, and then
the MAC address of the net-
work interface board.
The following is a sample configu-
ration using the registration
number 3 with the IP address
192.168.15.16:
msh> snmp 3 ip 192.168.15.16
Access
type
Type of access permitted
read Read only
write Read and write
trap User notified of trap mes-
sages.
no All access denied.

Table of Contents

Related product manuals