Gestetner 5308L User Manual

105
6. REMARKS
Operation Notes
General Cautions
• While printing, do not turn off the main switch.
• While printing, do not open the door or covers.
• While printing, do not unplug the power cord.
• While printing, do not move the machine.
• Keep corrosive liquids, such as acid, off the machine.
• Open and close the door and covers softly.
• Do not put anything except originals on the machine.
• Do not spill liquid on the machine.
• When opening or closing the door or covers, keep hold of them so they don't
fall.
• When removing the drum unit from the machine, be careful not to let the
drum unit fall.
• Do not modify or replace any parts other than the ones specified in this man-
ual.
• Do not operate the machine without covers. You might get your fingers
caught in the machine, or the machine might be damaged because, for exam-
ple, dust or the like might get inside.
• Since some parts of the machine are sharp and might cause injury, touch only
the parts specified in this manual.
• If you clean rubber parts with benzine, wipe them with a dry cloth after-
wards.
• Always turn the machine off when you have finished printing for the day.
• If the machine must be transported by vehicle, please contact your service
representative.
• Make sure to make a few trial prints to check the image position because the
image position of the trial print might not correspond with that of the origi-
nal.
• If the image registration is not consistent, slow the printing speed down to
Setting 0.
• When performing duplex or multicolored printing, leave the printed paper
for a while before the next printing in order to let the ink dry on the printed
paper. If this is not done, feed roller marks will appear on the print image.

Gestetner 5308L Specifications

General

Brand	Gestetner
Model	5308L
Category	Copier
Language	English

Summary

6. REMARKS

Where To Put Your Machine

Details optimal environmental conditions and environments to avoid for proper machine placement and performance.

7. SPECIFICATION

Main Frame

Details the configuration, printing process, original size, pixel density, and image modes of the main frame.

Safety Information

Safety During Operation

Highlights important symbols and provides critical warnings and cautions for safe machine operation.

Operation Panel

Indicators

1. Operation

Adjusting the Print Image Position

Details methods for shifting the printed image forward/backward or left/right using keys or dials.

Adjusting the Print Image Density

Guides on how to adjust print image density before or after master making using specific keys.

Security Mode—Printing Secret Documents

2. Optional Functions

3. Service Program Mode

Accessing Service Programs

Details the procedure to enter the machine's service program mode for adjustments and settings.

Changing the Settings of Service Programs

Guides on how to enter and store desired values or modes within service programs.

4. Replenishing Supplies

When the Add Ink Indicator (j) Lights

Master Roll Replacement

5. What to do If Something Goes Wrong

If Your Machine does not Operate as You Want

Troubleshooting guide for machine malfunctions, referencing indicators and guidance display messages.

When the misfeed indicator (x) lights

Provides solutions for various paper and master jam errors indicated by the misfeed indicator.

When the open cover/unit indicator (M) lights

When the supply/exchange indicators light

When other indicators light

Poor Printing

Dirt on the Back Side of Paper

Dirt on the Front Side of Paper (Black Line/Stain)

White Prints or Incomplete Prints

Clearing Misfeeds

Detailed instructions for clearing various types of paper and master jams within the machine.

PAPER FEED JAM. REMOVE JAMMED PAPER

Specific steps to resolve paper feed jams, including pulling paper gently and removing it from the drum.

MASTER EJECT JAM. REMOVE JAMMED MASTER

Instructions for clearing a master jam in the master eject section by removing the master eject box.

DELIVERY JAM. REMOVE JAMMED PAPER

Guidance on clearing paper jams in the delivery section, ensuring proper plate positioning.

When the Master Eject Indicator (k) Lights