Gestetner DSm415 - Page 103

Remote Maintenance by telnet
97
9
SLP
Use the "slp" command to configure
SLP settings.
You can search the NetWare server
using SLP in the PureIP environment
of NetWare5/5.1, 6. Use the "slp"
command to configure the value of
TTL used by the SLP multi-cast-pack-
et.
Note
❒ The default value of TTL is “1”. A
search is executed only within a lo-
cal segment. If the router does not
support multi-cast, the settings are
not available even if the TTL value
is increased.
❒ The acceptable TTL value is 1 - 255.
msh> slp ttl {1 - 255}
SPRINT
Use the "sprint" command to view
and configure SCSI print (SBP-2) on
IEEE 1394.
Limitation
❒ You can use this function when the
optional IEEE 1394 board is in-
stalled.
❖
❖❖
❖ Viewing settings
The following command displays
the current IEEE 1394 (SCSI print)
settings:
msh> sprint
❖
❖❖
❖ Bidirectional configuration for IEEE
1394 (SCSI print)
msh> sprint bidi {on |
off}
Use this setting to select whether
IEEE 1394 (SCSI print) is bidirectional
or not. The default is “on”.
Setting IEEE 802.11b
Use the "wiconfig" command to con-
figure IEEE 802.11b settings.
Limitation
❒ You can make settings when in-
stalling the optional 802.11b inter-
face kit.
❖
❖❖
❖ View settings
The following command displays
the current IEEE 802.11b settings.
msh> wiconfig
The following command displays
the IEEE 802.11b card information.
msh> wiconfig cardinfo
Note
❒ If the IEEE 802.11b interface is
not working correctly, the IEEE
802.11b card information is not
displayed.
❖
❖❖
❖ Configuration
Parameter Value to be
configured
mode
[ap|802.11adhoc|
adhoc]
You can set infra-
structure mode
(ap), 802.11 ad hoc
mode
(802.11adhoc), or
ad hoc mode (ad-
hoc).
The default is
802.11 ad hoc
mode.