Gestetner DSm415 - Page 43

User Tools Menu (System Settings)
37
3
Limitation
❒ Enter [Scope ID] using up to 31
alphanumeric characters.
Note
❒ Default: OFF
❖
❖❖
❖ SCSI print (SBP-2)
When you print using the SCSI
print client function supported by
Windows 2000 or Windows XP,
you must set SCSI print.
• Active
• Inactive
Note
❒ Default: Active
❖
❖❖
❖ Bidirectional SCSI print
Specifies the printer's response
mode etc. for status requests when
using the IEEE 1394 interface.
• ON
• OFF
Note
❒ Default: ON
❒ If this is set to [OFF], bidirection-
al communication will not
work.
❖
❖❖
❖ Host Name
Specify the host name.
❖
❖❖
❖ Domain Name
Specify the domain name.
Interface Settings/IEEE 802.11b
Preparation
You must install the IEEE 802.11b
(wireless LAN) board (optional)
into the machine.
Note
❒ Be sure to make all settings simul-
taneously.
❖
❖❖
❖ Communication Mode
Specifies the communication mode
of the wireless LAN.
• 802.11 Ad hoc
• Ad hoc
• Infrastructure
Note
❒ Default: 802.11 Ad hoc
❖
❖❖
❖ SSID Setting
Specifies SSID to distinguish the
access point in infrastructure
mode or 802.11 ad hoc mode.
Limitation
❒ The characters that can be used
are ASCII 0x20-0x7e (32 bytes).
Note
❒ Default: blank (ASSID)
❒ If blank is specified in 802.11b
ad hoc mode or ad hoc mode,
“ASSID” appears.
❖
❖❖
❖ Channel
Specifies a channel when you se-
lect 802.11b ad hoc mode or ad hoc
mode.
Note
❒ Default: 11
❒ The following channels are
available:
• Metric version: 1-13
• Inch version: 1-11