Getac B300 - Page 2

For the functions of ports and connectors, see chapter 1 of the B300 Ope
r
ation Manual.
* Standard Installation – Use the RED & BLACK wires to utilize the power switch on vehicle docking.
* By-Pass Installation – Use the BLUE & BLACK wires to continuously power vehicle docking and bypass the power switch.
** Use only the BLACK, RED or BLUE wires to connect to the vehicles electrical system. DO NOT power the vehicle docking
through the 19 volt input jack. This input jack is to be used only with the AC adapter provided by GETAC.
Power Switch w/ Red “POWER” LED
Keylock Hole
Expansion Bus Connector
PS/2 Mouse & Keyboard Ports
Microphone Connector
** 19 Volt Input Jack
LAN Port
Audio Output Connector
USB Ports
Serial Connectors
* Red, Black & Blue Wires w/ Disconnect
VGA Port
Expansion Bus Connector Push/Pull Latch
The red LED light, built into the power switch, indicates that there is power to the unit.
Standard Installation – In this set-up, the power switch can be turned on and off to regulate power through the unit.
By-Pass Installation – In this set-up, the unit is continuously powered (bypassing the power switch) and the red LED light
is lit regardless of switch position.