Getac K120 - Using Recovery Partition

59
Using Recovery Partition
When necessary, you can restore your Windows 10 system to the factory default
state by using the “recovery partition” feature. Recovery partition is a portion of
your hard disk drive that is set aside by the manufacturer to hold the original image
of your system.
WARNING:
 Using this feature will reinstall Windows to your system and
configure it to the system’s factory default settings. All
data on the hard disk drive will be lost.
 Make sure that power is not interrupted during the recovery
process. An unsuccessful recovery may result in Windows
startup problems.
To restore your system to the factory default state:
1. Connect the AC adapter.
2. Run BIOS Setup Utility. Select Advanced  Recovery Partition.
3. Follow the onscreen instructions to complete the process.