15
3. Align and attach the bracket to the add-on card’s bracket and tighten one
screw.
4. Align the add-on card’s connector with the slot and firmly press the connector
into the slot. Secure the bracket with two screws (the screws from step 2).
CAUTION: To prevent damaging the golden fingers of an add-on card, do not use
excessive force when inserting the gold fingers into the slot.
5. Four rubber pads of two different sizes are supplied with the Expansion Unit
or your computer. As add-on cards come in different sizes, you can use a
rubber pad to help holding a card that might need extra support.
Detach the release liner from the adhesive tape on the pad, fit the notch of
the pad to the edge of the add-on card where appropriate, and stick the pad
to the printed circuit board. (See the figure above for reference.)
Shown here is an example
of an add-on card.
Rubber pad (optional)
To Next Page
Loading...
