14
4
. Installing an Add-on Card
NOTE:
Before using an add-on card, it is suggested that you send the card to Getac
for compatibility test.
The PCI slots do not support “ATA 66” add-on cards.
PCI model PCIe model
1. If your computer has the Expansion Unit already attached, you have to partially
disassemble the Expansion Unit in order to access the expansion slots. (See
Section 3 for disassembly instructions.)
If the Expansion Unit was purchased separately and has not been attached to
the computer yet, see Section 2 for information.
2. Depending on which slot you want to use, remove its bracket by unfastening
two screws.
Slot 2
Slot 1
Slot 2
Slot 1
To Next Page
Loading...
