Getac X600 Series - Attaching the Expansion Unit

3
2 . Attaching the Expansion Unit
NOTE: Skip this section if your computer model is X600 Pro-PCI.
If you have purchased the Expansion Unit separately for a standard X600 model,
follow the instructions in this section to attach the Expansion Unit to the bottom
of the computer.
The process includes five major parts.
Part 1: Make X600 ready for the installation.
Part 2: Disassemble the Expansion Unit.
Part 3: Attach the Expansion Unit cabinet to the computer.
Part 4: Reassemble the Expansion Unit.
Part 5: Install the battery packs and the optical disc drive.
Part 1
1. Remove the two battery packs from X600.
To remove a battery pack, pull its ribbon strip toward the right to unlock and
then pull the battery pack out of the compartment.
2. Remove the DDR cover from the bottom of X600 by unfastening 15 screws (as
indicated by the arrows below).
NOTE: The DDR cover will not be needed as long as the Expansion Unit is installed.
https://advavee.com/