4
3. Detach the docking connector piece by unfastening three screws (as indicated
by the arrows below). Note that there are cable connectors to be unplugged.
Detach the antenna pass-through piece if your model has it.
NOTE: The two pieces will not be needed for the Expansion Unit, meaning the
functions are not available when the Expansion Unit is installed.
4. Unfasten 11 screws (as indicated by the arrows below). One of them is from
the DDR holder while the others are from the bottom cover.
Antenna pass-
through piece
Docking connector
piece
To Next Page
Loading...
