7
INSTALLATION
This pre-installation instruction covers the information needed to pre-
pare the installation site, before delivery of the unit.
With the delivery of the machine a specific installation instruction will
be enclosed. A copy of the specific instruction is also enclosed in the
manual.
The specific instruction may also cover details such as:
• Unpacking
• Rigging and transportation within the facility
• Reassembly of the dismounted equipment
• Functional test prior to use.
General requirements to be met by the installation
location
Use Getinge Sterilization AB’s installation drawings for design and
building purposes when determining the necessary dimensions and
design. Experience has shown that particular attention should be paid to
the following points.
• The ceiling height in the service room must be sufficient to allow
space for all equipment according to the installation drawing.
• The service room must have good lighting and be ventilated. For
requirements regarding ventilation, see the special section on this
topic in this instruction manual.
• All dimensions relating to foundations, floor pits, wall openings, etc.
refer to finished dimensions. These dimensions must be complied
with when floor, wall and ceiling linings have been installed.
• When choosing the wall covering in the service room it should be
kept in mind that the room may be filled with steam the event of a
failure.
• The equipment must be set up so that the distance to the nearest
workplace or treatment position is more than 1.5 meters (5 foot).
• The floor in front of the door(s) of the sterilizer must be flat and level
within in a zone as shown in the diagram below. When installing
several sterilizers that are to be served by a common loader, the
width of this area must be the same as that of the entire installation.
To Next Page
Loading...
Need help?
General
