9
Unpacking
• Check when unpacking the equipment that the order No. of its data
plate conforms with the ordering No. of the documents.
• Check that the sterilizer is faultless. Any transportation damage
should be reported within seven days to the transport company that
was responsible for delivery.
• Do not remove the protective plastic film from stainless steel panels
until the installation is completed.
• There is certain equipment such as expendable items, control unit,
operating instruction and list of programs by-packed the sterilizer
inside the chamber. The two latter are to be posted where easily
observed by the operator at work.
Storage
The unit must be stored in a temperature between 2 and 40
o
C (35 and
105°F) and at a maximum relative humidity 95% (non-condensing).
Installation
• Observe national and local regulations concerning service space.
• Make sure that the clearance distances required by health and safety
regulations are provided.
Please note that those articles are adapted for each steril-
izer. When unpacking more than one sterilizer the articles
are not to be interchanged.
To Next Page
Loading...
Need help?
General
