Paper guide accessories
GETINGE recommend the use of a paper guide for convenient feeding and
trouble-free transport of the material.
−
Remove the feed plate and install the paper guide.
−
To set the seam width, slacken the knurled nut on the paper guide to
release the feed stop. Move the feed stop to the required position and
tighten the knurled nut.
With the feed stop fully forward, the seam is about 5 mm away from the
cut-off edge of the material; with the feed plate fully back it is about 35
mm away from it.
4 Overview of controls
1.
Temperature selector switch
2.
Temperature setting scale
3.
Indicator lamp (temperature)
4.
Motor on/off switch
5.
Indicator lamp (motor)
GS-43-GB-002.doc
5
To Next Page
Loading...