ULTIMA series MAINTENANCE OF THE WASHER
NU_ULTIMA_02_EN_1612 59
5. EXTERNAL MAINTENANCE OF THE WASHER
GETINGE LANCER washers are entirely covered with panels (bodywork) in stainless steel AISI 304L.
5.1 CLEANING METHOD
Regular maintenance cleaning is done using a soft cleaning product.
In the event that regular cleaning tasks have been neglected for too long, we recommend using a special cleaner.
The product must be wiped on using a cloth or a soft sponge, being careful to rub the stainless steel in the direction
of the grain on the panel to avoid any scratches.
For drying, good practice is to use a rubber scraper, as you would on glass surfaces; this avoids any shimmering
effect that can be produced when cleaning with a cloth.
AVOID WATER RINSING DIRECTLY ON THE WASHER
5.2 CLEANING PRODUCTS FOR EXTERIOR PANELS
DETERGENTS, WASHING LIQUIDS:
All types of detergents, washing liquids and commercial soaps are generally usable, as long as they do not contain
chlorinated products.
ABRASIVE POWDERS:
These products can scratch stainless steel surfaces and therefore change the appearance, at least in small areas.
However, they can be useful to remove stubborn stains through rubbing.
ACID PRODUCTS:
The use of acid-based cleaning products should only be used in special cases.
Acetic acid can be used to remove stains caused by the buildup of limescale.
There are phosphoric acid or nitric acid based products that are specially designed for cleaning stainless steel.
Strictly follow the manufacturer instructions when using them.
Chlorinated disinfectants should only be used sparingly:
solution diluted in cold water, reduced contact time, rinse well.
AFTER CLEANING IT IS NECESSARY TO ABONDANTLY RINSE WITH A
SOFT CLOTH TO REMOVE TRACES OF THE CLEANING PRODUCTS
THAT WERE USED
To Next Page
Loading...
Need help?
General
