ULTIMA series GENERAL INFORMATION
NU_ULTIMA_02_EN_1612 7
CHAPTER 2
GENERAL INFORMATION
1. GENERAL CONSIDERATIONS
1.1 COPYRIGHT – LIABILITY
All rights reserved.
GETINGE LANCER pays close attention to all technical developments and continuously seeks to improve its
products and services in order to provide an adequate response to the needs of its clients. GETINGE LANCER
therefore reserves the right to modify the related documentation without prior notice.
1.2 DECLARATION OF CONFORMITY
This ULTIMA series washer has been developed and manufactured following the standards (CE
or UL).
For the washers in conformity with the CE standards, a “CE conformity declaration” is delivered
with the machines.
1.3 MANUFACTURER
This ULTIMA series washer is manufactured in our Center of Excellence for glassware washers :
GETINGE LANCER
30, Bd de l’Industrie
Zone industrielle Pahin Concerto
31170 Tournefeuille - France
2. SAFETY WARNINGS
2.1 CORRECT USAGE
The installation of the ULTIMA series washer must be achieved in accordance with the procedures described in the
installation manual delivered with the machine.
This section contains important information on how to operate your washer. Follow the instructions in this manual
carefully for best outcome.
ULTIMA series washers are equipped with a number of safety devices. To avoid injury, do not by-pass or disable
these devices.
Do not tamper with or attempt to modify these devices, as this could prove dangerous.
To Next Page
Loading...
Need help?
General
