Operating instructions
5000376-00 Version 990426 11
For certain process faults, information about the cause of the fault appears in
the display window on the front panel. Certain fault messages must be
acknowledged once the fault has been remedied (no acknowledgement is
required for a message indicating the need to fill with an agent); see also under
the heading, "Acknowledging a fault message".
Fault message Note Measure
Temperature sensor Contact the authoriz
Fault message requiring attendance by a service technician
F1
F2
fault. service personnel.
Tank level sensor Contact the authorized
fault. service personnel.
Machine Contact the authorized
configuration service personnel.
Inspection Contact the authorized
service personnel.
Disinfection Contact the authorized
temperature service personnel.
Lid unlocked/open Contact the authorized
service personnel.
Fault in check sum Contact the authorized
service personnel.
Tank level not Contact the authorized
reached service personnel.
Leakage Contact the authorized
service personnel.
Lid operating time Contact the authorized
service personnel.
Rotator operating Contact the authorized
time service personnel.
Logic fault in rotator Contact the authorized
service personnel.
Communications Contact the authorized
fault, EEprom service personnel.
F5
F6
F7
F10
F11
F8
F9
F16
F15
F14
F17
To Next Page
Loading...
Need help?
General
