Need help?Do you have a question about the Getinge FD1800 and is the answer not in the manual?
General| Type | Washer-disinfector |
|---|---|
| Capacity | 180 liters |
| Power Supply | 400 V, 3-phase, 50/60 Hz |
| Power Consumption | 12 kW |
| Certifications | EN ISO 15883, CE |
| Noise Level | 65 dB |
| Programs | Multiple programmable cycles |
General safety rules for operating the machine.
Actions to take in case of an emergency.
Getinge's product liability statement.
Requirements for the machine's isolating device.
Defines the primary purpose of the flusher disinfector.
Explains the meaning of various warning symbols used in the manual.
Recommendation for using a residual current device.
Overview of the flusher disinfector's purpose and design.
Explains the cleaning and disinfection process.
Piping and instrumentation diagram of the machine.
Details on the machine's cooling methods.
Location and access instructions for the inspection hole.
Ease of access for service and installation.
How maintenance and service personnel set parameters.
Procedures for accessing and navigating the service program.
Details on machine-independent settings and variables.
Sets the method for dosing cleaning agents.
Configures the audible signal for door closing.
Specifies the type of door operation (manual, auto, IR).
Enables or disables audible alarms for faults and program end.
Activates and adjusts the feedback function.
Selects the unit for temperature display (°C or °F).
Adapts to the electricity supply network frequency.
Sets the pump starting time.
Configures the function of the red indicator LED.
Sets the temperature for activating condensate cooling.
Sets the time for door cracking open.
Defines how long the door stays cracked open.
Specifies which flushing program to call.
Sets available flushing programs for buttons.
Links programs to selection buttons and defines program names.
Configures and manages interval disinfection functions.
Manages continuous maintenance service reminders and warnings.
Sets the dosing time for various agents used in a process.
Specifies how empty container alarms are managed.
Details on disinfection methods, temperatures, and times.
Selects the method for cooling items after disinfection.
Settings for tank level, water type, and mix ratio.
Settings for rim flushing, soft water, and cooling times.
Explains fault messages displayed on the front panel.
Lists warning codes that do not require acknowledgment.
Lists warning codes needing action before restart.
Procedure for acknowledging fault messages.
Procedure for resetting the machine.
Lists errors, their causes, and recommended actions.
Overview of periodic maintenance tasks and intervals.
Checks for general components like cabling, fan, and door lock.
Procedures for cleaning and inspecting the process tank and its components.
Checks and cleaning procedures for the steam generator.
Maintenance for circulation pump, dosing hoses, and dosage amount.
Inspection of drainage connections and automatic door function.
Procedures for performing test runs, including temperature checks.
Steps for checking machine functions and components.
Checks for signs, instructions, and the isolator switch.
Checks on valves, filters, and pipe couplings.
Checks the panel lights and buzzer operation.
Inspection of electrical cables, fuses, and fan.
Checks fan rotation, airflow, and cleanliness.
Verifies door lock, catch, and seal integrity.
Inspection and replacement of nozzles and temperature sensors.
Checks chamber seals, item holder points, and overflow connection.
Procedure for draining the steam generator.
Procedure for draining the circulation pump.
To Next Page
