Page 43 av 64
<Doc_TEC><Doc_503712400><Rel_B><Lang_EN>
Acknowledging a fault message
This must only be done by authorized personnel.
Some messages need to be acknowledged before the machine can be returned to run
mode. When the cause of the fault has been found and the fault has been put right, the
fault message is acknowledged as follows:
First press the
button, then the button. Keep both buttons pressed at the same
time for 10 seconds.
Resetting the machine
This must only be done by authorized personnel.
When resetting a machine, , and must be pressed at the same time for
20 seconds.
To Next Page
Loading...
Need help?
General
