Page 9 av 64
<Doc_TEC><Doc_503712400><Rel_B><Lang_EN>
Safe and simple
Disinfection is fully automatic
• safety and reliability can be kept high by continuous monitoring of the process.
• the dosing of descaler, the temperature and the disinfection time can all be altered
with great precision to suit different conditions.
• the built-in service program makes troubleshooting and servicing far easier.
Operation is simple and the control buttons are few and clearly marked.
Simple service and installation
Valves and the electrical equipment are easily accessible for inspection and service from
the front and from above.
Cooling
Cooling with ventilator (optional)
The items can be cooled by the ventilator fan sucking the warm air out from the chamber.
Internal cooling (optional)
Internal cooling takes water from the tank and the standard water supply.
This method is not recommended according to EN ISO 15883.
Inspection hole
The inspection hole is located in the front left corner of the chamber.
In order to access the inspection hole, remove the front plate.
Inspection hole
To Next Page
Loading...
Need help?
General
