Getinge FD1800 User Manual

Page 11 av 64
<Doc_TEC><Doc_503712400><Rel_B><Lang_EN>
Service program
Function
In the service program, maintenance and service personnel can set parameters which
control the operation of the machine. These parameters are divided into the following
groups:
• Machine-independent settings
• Conguration
• Program selection
• Interval disinfection
• Inspection request
• Dose size
• Empty container alarm
• Disinfection
• Tank and water
• Fault statistics
• Program statistics
• Function test
• Activation of inputs and outputs
• Switching of inputs and outputs
The facility for changing line information is protected by authorization codes, so as not
to put the operation of the machine at risk. There are four passwords with different levels
of authorization:
• LevelA for users; display only (code 0000)
• LevelB for users; change (code 2000)
• LevelC for service personnel, change
• LevelD for service personnel, critical settings.
You can always view all higher-level program lines without the authorization code for
those levels. The code only protects against changes.
The operator communicates with the service program via the pushbuttons on the front
panel and via the display.
The information in the memory of the machine is structured as a number of lines,
where every line has a two-digit line number (00 - 99). On every line there is either line
information or a control for a certain function, e.g.:
On program line 11 you can switch child safety on or off.
Line Parameter Basic setting Setting range Authorization
11 Child safety 0 0=No, 1=Yes BCD
A line can also contain several sub-line numbers. Each sub-line has a particular function,
e.g.:
On program line 30, you can choose, with the aid of the sub-lines, which program (of up
to 25) will start when a button or a combination of buttons is pressed.

Getinge FD1800 Specifications

General

Brand	Getinge
Model	FD1800
Category	Cleaning Equipment
Language	English