Page 5 av 64
<Doc_TEC><Doc_503712400><Rel_B><Lang_EN>
SAFETY REGULATIONS
This machine has been designed with a number of built-in safety devices. To avoid
injury, it is highly important not to bypass or disable these safety devices.
General safety regulations
• Take care when handling the chemical agent used in the machine.
Read the details on the container or contact the manufacturer:
- if the agent comes into contact with the operator’s eyes or skin or if the vapors
are breathed in, etc.
- about storing the agent and disposing of empty containers.
• The machine must be connected in accordance with the installation instructions.
• Read the instructions thoroughly before use.
• The machine may only be operated by adults.
• Installation and service work must be done by personnel trained for this machine.
• The door locks of the machine must never be bypassed.
• Leakage in the system, due to a worn door seal for example, must be repaired
without delay.
• Before repair or service work is done, the personnel concerned must study the
relevant documentation and service manuals.
• Before welding begins on or close to the machine, all wiring connected by plugs
and sockets must be disconnected from all circuit boards of the control system.
• The machine must not be hosed down with water.
• Take care when using corrosive detergents.
• Precautions must be taken with hot water and steam.
• Run a program before starting servicing work. If this is not possible, disinfect the
machine with disinfectant before starting servicing work.
In an emergency
• Switch off the main switch.
• Close shutoff valves in the water and (where present) steam supply lines.
Product liability
Any modication or incorrect use of the equipment without the approval of Getinge
Disinfection AB invalidates Getinge Disinfection AB’s product liability.
This product was manufactured by:
GETINGE DISINFECTION AB
Ljungadalsgatan 11, Box 1505
SE-351 15 Växjö, Sweden
Isolator switch
The machine must be tted with a separate isolating device in the electric power supply.
The isolating device must be easily accessible on a wall close to the machine.
To Next Page
Loading...
Need help?
General
