GEZE GC 307+ - User Manual

Translation of the original instructions for device version 0200
T
Technology Radar movement detector
Frequency 24,150 GHz
Power ux density < 5mW/cm
2
Radiated power < 20 dBm EIRP
Detection range (hand) ±10 … 60cm (movement towards
sensor, angle 90°), adjustable*
Type of detection Movement (independent of direction)
Speed of objects for de-
tection
Min. 5Hz or ±3cm/s,
Max. 200Hz or ±1.2m/s
Power supply ** 12–24 V AC ±10 %
12–24 V DC +30 %/–10 %
Mains frequency 50 … 60 Hz
Power consumption < 1.5 W
Output Changeover relay (potential-free contact)
à Max. contact voltage 42V AC/DC
à Max. switching current 100 mA
Holding time 0.5s (in PULSE mode)
Temperature range –20 °C … +55 °C
Protection class IP 65 (if front and seal are installed on a
smooth surface)
Material PC
Colour White
Recommended cable Braided cable up to 16 AWG – 1.5 mm
2
* Adjustment of the detection eld < 10 cm is possible, but the detec-
tion capacity of the sensor can then no longer be guaranteed.
** The unit must be supplied by an approved SELV-limited current
source of Class II. This requirement is the need for double insulation
between primary voltages and the unit supply. The power supply
should be limited to 1.5 A.
The GC307+ can be installed behind tiles,
wood, plaster, plastic and glass.
Do not install the GC307+ behind
metallic surfaces.
Do not install the GC307+ in the
swivelling range of doors.
Avoid moving objects near the GC307+.
Intended use
The movement detector GC 307+ may only be
used to activate automatic sliding,
curved sliding, folding, swing or revolving doors
with GEZE drives.
195727 (Hand-Icon)
195751 (WC-Icon)
193226 (Hand-Icon)
195750 (WC-Icon)
GC 307+
198725-01

GEZE GC 307+ Specifications