Need help?Do you have a question about the GEZE Powerturn and is the answer not in the manual?
General| Protection Class | IP20 |
|---|---|
| Operating Voltage | 24 V DC |
| Power Consumption (alternative) | 100 W |
| Holding Open Time | Adjustable |
| Max Door Width | 1400 mm |
| Power Supply | 230 V AC |
| Closing Force | EN 4-7 |
| Max Door Weight | 600 kg |
| Operating Temperature | -20°C to +50°C |
| Ambient Temperature | -20°C to +50°C |
Essential safety guidelines for installation, operation, and maintenance.
Precautions and risks during installation to prevent injury.
Measures for checking safety functions and preventing crushing, impact, or shearing points.
Information on installing and configuring the GC 338 safety sensor strip.
Details for installing and configuring the GC 342 safety sensor.
Details on the GC 334 safety sensor, including installation and testing.
Information on the GC 335 safety sensor, including master and extension modules.
Using the DPS for commissioning, servicing, and changing drive parameters.
Integrating the lintel smoke switch into extension kits for Powerturn F/R door drives.
Configuring hold-open systems with automated active leaf, passive leaf, door closer, and holding magnet.
Requirements and procedure for initial setup and commissioning of the drive system.
Steps for teaching the drive the door's movement parameters and safety sensor functions.
Detailed steps for teaching the drive parameters for a single-leaf door system.
Detailed steps for teaching the drive parameters for a two-leaf door system.
Setting and understanding forces and speeds for drive operation, including obstacle detection.
Providing manual opening support with additional torque, even under adverse conditions.
Enhanced manual opening support for fire protection doors with fire alarm signal.
Operating the ST220 service terminal for commissioning, parameter changes, and diagnostics.
Overview of the ST220 service menu structure, including parameter settings and main menu access.
Parameters for setting the drive's operating mode (e.g., Automatic, Night mode).
Parameters related to door weight, leaf width, and control type for system configuration.
Parameters for drive movement, including speeds, latching action, and obstacle detection.
Parameters for safety sensors (SI, SIS, SIO) and inputs (KB, KI, KA, PE).
Viewing current input/output states, internal values, temperatures, and statistics for troubleshooting.
Displaying and interpreting fault messages on the ST220 terminal and DPS.
Interpreting fault codes displayed via service button LEDs (S1, S2) and mode LEDs.
To Next Page
