EasyManua.ls Logo

GEZE SL NT - Safety Conscious Working; Inspection of the Installed System; Environmentally Conscious Working

GEZE SL NT
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Slimdrive SL NT/SL NT-FR
5
Safety
3.3 Safety conscious working
à Secure workplace against unauthorised entry.
à Watch pivoting range of long parts.
à Never carry out work with a high safety risk (e.g. installing the drive, cover or door leaf) while alone.
à Secure the cover/drive panels against falling.
à Use only cables prescribed in the cable plan provided. Lay shields in accordance with the wiring diagram.
à Secure loose, internal drive cables with cable ties.
à Before working on the electrical system:
à Disconnect the drive from the 230 V mains and check to ensure that it is not supplied with power.
à Disconnect the control from the 24 V battery.
à Note that if an uninterruptible power supply (UPS) is used, the system will still be supplied with power
despite the fact that the power supply is disconnected.
à Always use insulated wire-end ferrules for wire cores.
à Attach safety stickers to glass door leaves.
à Danger of injury with opened drive. Hair, clothing, cables, etc. can be drawn in by rotating parts!
à Danger of injury through unsecured crushing, impact, drawing-in or shearing spots!
à Danger of injury by broken glass!
à Danger of injury due to sharp edges in the drive!
à Danger of injury during installation through freely moving parts!
3.4 Inspection of the installed system
Measures for security and prevention of pinching, impact, shearing or drawing-in spots:
à Check the functioning of safety sensors and movement detectors.
à The detection eld of the movement detector in the direction of the emergency exit must cover the opening
width x 1.5 m in front of the door.
à The movement detector in the direction of the emergency exit (see AutSchR) must detect people moving
faster than 0.1 m/s.
à Check protective earth connection to all metal parts that can be touched.
à Perform a safety analysis (risk analysis).
3.5 Environmentally conscious working
à When disposing of the door system, separate the dierent materials and have them recycled.
à Do not dispose of batteries and storage cells with household waste.
à Comply with the statutory regulations when disposing of the door system and the batteries/rechargeable
batteries.