Need help?Do you have a question about the GF Piping Systems TM 250 ECO and is the answer not in the manual?
Specifies the intended use of the TM 160/250/315 machines for PE and PP pipes.
Outlines general safety precautions for operating the machine, including using original parts.
Emphasizes workplace safety and handling precautions for the machine.
Defines the exclusive application of the TM 160/250/315 ECO for thermoplastic pipes.
Explains connecting and operating the temperature regulator for the heating element.
Details the procedure for calculating the machine drag pressure before fusion.
Describes the steps for preparing pipe surfaces using the planer.
Explains how to calculate the required fusion pressure based on table values.
Provides step-by-step instructions for adjusting the fusion pressure.
Details the steps for the equalization phase of the fusion process.
General| Model | TM 250 ECO |
|---|---|
| Category | Welding System |
| Voltage | 230 V |
| Material Compatibility | PE, PP, PVDF |
| Control System | Manual |
| Heating Element | Integrated |
| Pipe Diameter Range | 20 mm - 250 mm |
To Next Page
