Need help?Do you have a question about the GF Piping Systems TOP 2.0 630 and is the answer not in the manual?
Explanation of warning symbols and their meanings for safety.
Ensuring the machine is used only for its intended purpose.
Essential safety practices for operating and maintaining the machine.
Procedures and precautions for safe operation and handling of the machine.
Key technical data for the TOP 2.0 butt fusion machine models.
Procedure to adjust the heating element's temperature and confirm settings.
Method for calculating the initial drag pressure required before fusion.
Steps for preparing pipe ends, including planing and cleaning surfaces.
Formula to determine the correct fusion pressure based on table values and drag pressure.
Procedure to set and fine-tune the fusion pressure for optimal joint quality.
Procedures for replacing parts like PTFE coating and planer blades.
General| Product Category | Welding System |
|---|---|
| Size | 630 |
| Product Name | TOP 2.0 630 |
| Nominal Diameter | 630 mm |
| Material | PP |
| Pressure Rating | 10 bar |
| Standard | ISO 21307, ISO 12176-1 |
| Connection Type | Butt Fusion |
To Next Page
