GFI System SPECULAR REVERB V3 - Operation and Preset Management; Preset System Structure

5
CHAPTER2‐Operation
SAVEPRESET
1.Tap[PresetSelect]asmanytimesasneededtoreachthedesiredpresetlocation.
2.Hold[Engage]untilthePresetLEDflashes3x.
Fromthispointonward:
 [Engage]willrefertotheEngagefootswitch,
 [PresetSelect]willrefertothePresetSelectswitch,and
 [Mode/Edit]willrefertotheMode/Editpushbutton
Patch1 Patch2 Patch3 Patch4 Patch1 Patch2 Patch3 Patch4
BANK1 BANK2
PresetSystem
The8presetlocationsareorganizedin2banks,whereeachbankcontains4patches.
LOADPRESET
1.Tap[PresetSelect]toselectthedesiredpresetlocation.
2.Tap[Engage]oncetoloadtheselectedpreset.

Presetsareselectedbygoingthrougheachlocationinthe‘Up’direction(1,2,3,…),whilegoing
through these steps the sound does not get updated until
selection is confirmed by pressing
[Engage].

Spillover
: Reverb tail will be preserved when changing preset if and only if both source and
destinationpresetcontainsthesamealgorithm.

LOADAPRESETINADIFFERENTBANK
1.Tap[Engage]and[PresetSelect]togetheronce<—thistogglesthebank.
2.Tap[PresetSelect]asmanytimes
asneededtoreachthedesiredpresetlocation.
3.Tap[Engage]oncetoloadtheselectedpreset.
BYPASSORENGAGE
1.Tap[Engage]once.
6