GGF E Series - Electric Connection Procedures

12
Instructions for use and maintenance
Rev. 11/2013 - EN
INSTALLATION -5
5.2- ELECTRIC CONNECTION
The oven is supplied with a power supply cable located on the rear and without plug (FIG. 6 - Ref. 1).
The electric data are given on the CE marking plate (FIG.1).
THE ELECTRIC CONNECTION OF THE OVEN TO THE MAINS MUST BE PERFORMED
COMPULSORILY AND EXCLUSIVELY BY AN AUTHORIZED TECHNICIAN (ELECTRICIAN)
SATISFYING THE TECHNICAL AND PROFESSIONAL REQUIREMENTS STATED BY THE
REGULATIONS IN FORCE IN THE COUNTRY OF USE OF THE OVEN, WHO MUST ISSUE A
DECLARATION OF CONFORMITY FOR THE INTERVENTION PERFORMED.
THE MANUFACTURER DECLINES ALL LIABILITIES FOR DAMAGES TO PERSONS, ANIMALS,
AND THINGS CAUSED BY WRONG CONNECTIONS TO THE MAINS.
ONCE THE ELECTRIC CONNECTION HAS BEEN PERFORMED, THE AUTHORIZED
TECHNICIAN (ELECTRICIAN) MUST ISSUE A DECLARATION CERTIFYING THE
MEASUREMENT OF THE CONTINUITY OF THE EQUIPOTENTIAL PROTECTION CIRCUIT.
The connection to the mains must be performed by interposing an automatic or manual switch hav-
ing a suitable capacity in which the opening distance between the contacts is at least 3 mm.
The grounding cable must not be interrupted.
The power supply voltage with operating oven must not differ from the value of rated voltage of +/- 10
%.
It is compulsory to connect the device to the ground.
The wiring diagram of the oven can be found in Chap. 11.
FIG.6 (Power supply cable)
1