76
23. Reset of the MO 1
❖ Pressing either the top button-line of the MCP (s. fig. chapter 10.1 MANUAL
CONTROL PANEL) or the buttons L1 and L2 of the FCP simultaneously
(s. fig. 10 / chapter 13. FOOT CONTROL PANEL) for approx. 5 seconds - you
will hear some acoustic signals (beep) - resets the software.
❖ Previously saved memory values are deleted.
24. Cleaning and maintenance of the MO 1
WARNING Always disconnect the MO 1 from the mains (unplug)
before cleaning and maintenance. RISK OF ELECTRIC SHOCK! RISK
OF FIRE!
WARNING! Remove possible dust accumulation at the power plug, at
the safety power socket and at all plug connectors regularly. RISK OF
FIRE!
WARNING! Always ensure that water or other liquids cannot get into
the housing and the fittings of the MO 1 or into the MCPs or the FCPs.
RISK OF ELECTRIC SHOCK! RISK OF FIRE!
❖ Do not wear any arm and finger decoration such as rings or bracelets while
carrying out any cleaning or maintenance operations. Otherwise you can scratch
and damage the upholstery and / or the material of the base of the MO 1
unintentionally.
❖ Use water or a mild cleaning agent which is suitable for the material only.
❖ Do not use extremely hot water for the cleaning of the MO 1.
❖ Do not use any hard sponges, scouring pads or floor clothes.
❖ Do not use any aggressive cleaning agents such as scouring powders, floor
cleaners, etc.
❖ Do not use any dishwashing detergents.
❖ Do not use any solvents or bleaching agents.
❖ Do not use any essential oils.
NOTICE! If you wish to use a disinfectant, it is essential to contact the
manufacturer of the disinfection agent beforehand to find out whether
their product is suitable for disinfecting the material in question.
To Next Page
Loading...
