Ghost Controls AXWV - User Manual

AXWV WIRELESS VEHICLE SENSOR
OVERVIEW
Sensor Probe
Control Board
Minimum of 20 Feet
Maximum of 100 Feet from
Operator Control Board
sensor cable
WARNING: This product can expose you
to chemicals including lead, which is known
to the State of California to cause cancer.
For more information, go to
www.P65Warnings.ca.gov
WARNING: DO NOT USE THIS DEVICE WITH LIVESTOCK OR OTHER ANIMALS.
NOTE: THIS VEHICLE SENSOR ONLY WORKS WITH GHOST CONTROLS OPENER SYSTEMS.
PLEASE READ THE INSTRUCTIONS INCLUDED WITH THIS ITEM PRIOR TO INSTALLING.
IMPORTANT ITEMS REQUIRED
Two (2) C Alkaline Batteries are required and not included. One (1) Ghost Controls Transmitter that already operates the gate.
KIT CONTENTS:
■ 1 – Control Board Cover with control board (to be installed above ground)
■ 1 – Sensor Probe with 10 foot cable (to be buried below ground)
■ 1 – 12" PVC Pipe
PREPARING FOR INSTALLATION:
■ Must be located at least 20 feet beyond the path of the moving gate.
■ Must be located where the driver of the approaching vehicle has clear view of the gate.
■ Bury Sensor Probe approximately 12" deep and as close to the driveway as possible for maximum detection
of moving vehicles.
■ The Control Board must be at least 6" above ground.
■ The Control Board also should be with 100 feet of the Ghost Controls receiver/control box.
NOTE
The operating distance may vary depending on Radio Frequency interference at each installation site. Avoid installing the sensor near
power lines, transformers or running motors.
PVC Pipe
Control Board
Sensor Probe
Control Board Cover

Summary

Overview and Kit Contents

Important Items Required

List of essential components and batteries needed for installation.

Kit Contents

Details the specific items included in the wireless vehicle sensor kit.

Preparation for Installation

Key considerations for positioning the sensor and control board.

Setting Up the Wireless Vehicle Control Board

Control Board Battery Installation

Guide to opening the control board cover and inserting batteries correctly.

Teaching the Transmitter to the Control Unit

Pairing the Transmitter

Steps to link the remote transmitter to the control unit for gate operation.

Testing the Sensor Probe

Sensor Probe Detection Test

Procedure to verify sensor detection using a metal object and observe LED indicators.

Installing the Wireless Vehicle Sensor

Location Planning and Battery Installation

Choosing the best location for radio range and installing batteries.

Digging Trenches for Sensor and Wire

Instructions on digging trenches to bury the sensor probe and connecting wires.

Final Installation and Testing

Digging Hole for PVC Pipe

Guidance on digging a hole to secure the PVC pipe for the control board.

Final Driveway Test

Testing the installed sensor by driving a vehicle past the probe.

Filling Trenches and Finalizing

Instructions to fill trenches and holes after successful testing.

Guide to LEDs and Warranty Information

LED Indicator Guide

Explanation of the function of each LED indicator on the control board.

Warranty Details

Information on the product warranty and registration for an extended warranty.

Ghost Controls AXWV Specifications

General

Brand	Ghost Controls
Model	AXWV
Category	Accessories
Language	English