BEFORE YOU BEGIN:
A 12 volt automotive/marine battery or Ghost Controls ABBT2 Battery Box Kit is required to power the operator.
Push-To-Open applications (gate that swings away from the property) will require the Ghost Controls push-to-open
bracket kit (AXPO).
If charging your system with the AC transformer, you will need to purchase 16 gauge stranded, 2-conductor low voltage
wire to connect the transformer to the gate operator control board. Up to 1,000 ft. of wire can be used.
For installations farther than 1,000 ft. from an AC power source, the Ghost Controls 10 Watt (AXDP) Solar Panel Kit
can be used to charge the battery. Up to 30 Watts of solar power can be used.
CUSTOMIZING YOUR GATE:
Information on additional accessories shown below can be found on the accessory page 66 or visit
www.ghostcontrols.com
Premium Remote
Transmitter (AXP1)
Wireless Vehicle Sensor
(AXWV)
Standard Remote
Transmitter (AXS1)
Water Resistant Remote
Transmitter (AXR1)
12V BATTERY REQUIRED, NOT INCLUDED
4
TSS 1 K I T
© G host C ontr ols
®
2 0 2 0
To Next Page
Loading...
