Maintenance
General Maintenance
Inspect all suspension bolts and tighten if necessary to required torque
settings.
Do not use high-pressure water sources to wash or rinse bicycle. Doing so
can displace any lubricants that are present, as well as possibly forcing
water and/or contaminants into the bearing that can harm the pivot and
bearing, reduce performance, and cause premature wear. Use only low
pressure water, or bucket water with a soft nylon bristle brush and mild dish
soap to clean the frame and components.
Always use Loctite
TM
Primer (#7649) and Loctite
TM
blue Removable
Threadlock (#242) or similar material on thread of fixing bolts of calipers
and rotors during re-assembly.
Replacement of rear shock
Steps 1:
Loosen the shock mounting bolt
and remove the shock.
Repeat Step 1 in reverse to reassemble the rear shock.
Shock mounting bolt
Shock mounting bolt
Recommended torque for the shock mounting bolt is 90-110 kgf-cm.
To Next Page
Loading...
