Gigabyte G1.Sniper 3 - Page 11

- 11 - Hardware Installation
Storage Interface Chipset: 
- 2 x SATA 6Gb/s connectors (SATA3 0/1) supporting up to 2 SATA 6Gb/s
devices
- 4 x SATA 3Gb/s connectors (SATA2 2/3/4/5) supporting up to 4 SATA 3Gb/s
devices
- 1 x mSATA connector
* The SATA2 5 connector will become unavailable when the mSATA connector is
installed with a solid state drive.
- Support for RAID 0, RAID 1, RAID 5, and RAID 10
* When a RAID set is built across the SATA 6Gb/s and SATA 3Gb/s channels, the
system performance of the RAID set may vary depending on the devices being
connected.
2 x Marvell 88SE9172 chips: 
- 4 x SATA 6Gb/s connectors (GSATA3 6/7/8/9) supporting up to 4 SATA 6Gb/s
devices
- Support for RAID 0 and RAID 1
USB Chipset: 
- Up to 2 USB 3.0/2.0 ports on the back panel
- Up to 4 USB 2.0/1.1 ports (available through the internal USB headers)
Chipset + 2 VIA VL810 Hubs: 
- Up to 8 USB 3.0/2.0 ports (4 ports on the back panel, 4 ports available through
the internal USB headers)
IEEE 1394 VIA VT6308 chip: 
- Up to 2 IEEE 1394a ports (available through the internal IEEE 1394a
headers)
Internal
Connectors
1 x 24-pin ATX main power connector 
1 x 8-pin ATX 12V power connector 
1 x PCIe power connector 
6 x SATA 6Gb/s connectors 
4 x SATA 3Gb/s connectors 
1 x mSATA connector 
1 x CPU fan header 
4 x system fan headers 
1 x front panel header 
1 x front panel audio header 
2 x USB 2.0/1.1 headers 
2 x USB 3.0/2.0 headers 
2 x IEEE 1394a headers 
1 x Clear CMOS jumper 
1 x power button 
1 x Clear CMOS button 
1 x reset button 
Voltage measurement points 
1 x BIOS switch 
1 x Trusted Platform Module (TPM) header 
Back Panel
Connectors
1 x PS/2 keyboard/mouse port 
6 x USB 3.0/2.0 ports 
1 x D-Sub port 