Gigabyte G1.Sniper Z97 - Page 23

- 23 -
Hardware Installation
Audio Gain Control Switches
The two switches allow for audio gain control for your headphone. Please make sure the two switches are set
inthesamepositionandaresetaccordingtoyourheadphonespecication.
2:6x
1:2.5x(Default)
CAP_SW2 (Left Channel)
1
2
F_USB30
F_U
B_ 
F_  F_ 

_
B
BS_
B
SB_
B
_S

S_
_
B
_U
_
B


 
S  
 
123
 
123
 
123
 
123
1
1
1
1
BSS
S
_S 
SSU
 
1 2 3  
 S3
BSSS
U
 __ 3
F_USB3F
S  _
S  _
S  _
SF


CAP_SW1 (Right Channel)
1
2
F_USB30
F_U
B_ 
F_  F_ 

_
B
BS_
B
SB_
B
_S

S_
_
B
_U
_
B


 
S  
 
123
 
123
 
123
 
123
1
1
1
1
BSS
S
_S 
SSU
 
1 2 3  
 S3
BSSS
U
 __ 3
F_USB3F
S  _
S  _
S  _
SF


Quick Buttons
This motherboard has 3 quick buttons: power button, reset button and clear CMOS button. The power button
and reset button allow users to quickly turn on/off or reset the computer in an open-case environment when
they want to change hardware components or conduct hardware testing. Use this button to clear the BIOS
congurationandresettheCMOSvaluestofactorydefaultswhenneeded.
PW_SW: Power button
RST_SW: Reset button
CMOS_SW: Clear CMOS Button
• Always turn off your computer and unplug the power cord from the power outlet before clearing
the CMOS values.
• NOTE: Do not use the clear CMOS button when the system is on, or the system may shutdown
and data loss or damage may occur.
• Aftersystemrestart,gotoBIOSSetuptoloadfactorydefaults(selectLoadOptimizedDefaults)or
manuallyconguretheBIOSsettings(refertoChapter2,"BIOSSetup,"forBIOScongurations).
CMOS_SW
PW_SW
RST_SW