System Hardware Installation - 26 -
3-1 Removing and Installing the Top Rear Cover
Before you remove the top rear cover:
• Make sure the system is not turned on or connected to AC power.
Follow these instructions to remove the top rear cover:
1. Remove the single screw securing the cover.
2. Loosen the two thumbnail screws securing the top rear cover in place.
3. Slide the cover towards the rear and remove the cover in the direction indicated.
4. Follow steps 1-4 in reverse order to re-install the top rear cover.
1
2
2
3
3
• The image below shows the top rear cover removal process for G482-Z50. The same process
applies to G482-Z51.
To Next Page
Loading...
