Gigabyte G482-Z50 - Page 98

BIOS Setup - 98 -
Parameter Description
Link
Press [Enter] for more options.

GMI encryption control
– Control GMI link encryption.
– Options available: Disabled/Enabled/Auto. Default option is Auto.

xGMI encryption control
– Control xGMI link encryption.Options available: Disabled/Enabled/
Auto. Default option is Auto.

CAKE CRC perf bounds control
– Control CAKE CRC perf bounds
– Options available: Auto/Manual. Default option is Auto.

4-link xGMI max speed
– Set 4-link xGMI max speed.
– Options available: 8.533Gbps/9.6Gbps/10.667Gbps/11Gbps/
12Gbps/13Gbps/14Gbps/15Gbps/16Gbps/17Gbps/18Gbps/
19Gbps/20Gbps/21Gbps/22Gbps/23Gbps/24Gbps/25Gbps/Auto.
Default option is Auto.

3-link xGMI max speed
– Set 3-link xGMI max speed.
– Options available: 8.533Gbps/9.6Gbps/10.667Gbps/11Gbps/
12Gbps/13Gbps/14Gbps/15Gbps/16Gbps/17Gbps/18Gbps/
19Gbps/20Gbps/21Gbps/22Gbps/23Gbps/24Gbps/25Gbps/Auto.
Default option is Auto.

xGMI TXEQ Mode
– Select XGMI TXEQ/RX vetting Mode.
– Options available: TXEQ_Disabled/TXEQ_Lane/TXEQ_Link/
TXEQ_RX_Vet/Auto. Default option is Auto.
Disable DF to external IP
Sync Flood Propagation
Disable SyncFlood to UMC & downstream slaves.
Options avaialble: Sync ood disabled/Sync ood enabled/Auto.
Default option is Auto.
Disable DF sync ood
propagation
Enable/Disable DF SyncFlood.
Options avaialble: Sync ood disabled/Sync ood enabled/Auto.
Default option is Auto.
Freeze DF module queues on
error
Controls DF PIE Cong. Disabling this options sets DF:PIECong.
Options available: Disabled/Enabled/Auto. Default option is Auto.
CC6 memory region encryption
Control whether or not the CC6 save/restore memory is encrypted.
Options available: Disabled/Enabled/Auto. Default option is Auto.
System probe lter
Controls whether or not the probe lter is enabled. Has no effect on parts
where the probe lter is fuse disabled.
Options available: Disabled/Enabled/Auto. Default option is Auto.
Memory Clear
When this feature is disabled, BIOS does not implement MemClear after
memory training (only if non-ECC DIMMs are used).
Options available: Disabled/Enabled/Auto. Default option is Auto.
PSP error injection support
Select True to enable error injection.
Options available: False/True. Default option is False.